The problem is that the wisher is broken away from the holding plastic and will loose contact completely. All pots are from the same manufacturer (Alps) and construction. I fixed it, and the fix is not too complicated. Some weeks ago I got this really impressive deck (Teac Z 7000) from a colleague, and found the same problem. SOURCE: My Teac Z-7000 will not record tapes With compression alone the result may still fall short as the use of pro quality mastering effects can really make a world of difference to overall percieved volume as well. Unfortunately even well recorded instruments and vocals naturally contain wide fluxuation in terms of lows and highs and these need to be smoothed out in order to obtain anywhere near the volume of a commercial CD. There are other factors like EQ without which a mix can sound too loud and perhaps cause you to lower the levels when really things in the mix just need to be allowed to sit in different EQ bands.Ĭompression is the key though. I do however use compression on many of the tracks (and sometimes on the whole mix) before exporting which will squash the peaks and lows together and thus give you an overall higher volume with your level meters peaking in the normal place you're used to. I don't typically normalize though and the levels are what has come out of the Tascam. I usually don't burn CD's from my Tascam directly, but export the mix to the PC and do final touches and burn from there. There's not really any magic fix to this as far as I'm aware. If that CD has proper volume then you may have some problem with your Tascam CD burner although I've never seen a situation where a burner actually caused low volume like this. If the volume is low there you aren't creating master tracks with good volume (see above: master fader level), if the tracks sound good as wavs on your PC, then burn them onto a cd from there. To troubleshoot, you might want to try exporting your master tracks as wav files onto your computer via usb and then listening to them there. You should however be able to reproduce onto CD the volume levels you are hearing on your Tascam without resorting to compression. Your master fader also needs to be set at 0db or above as this effects the volume when mastering.Ĭommercial CDs use a lot of compression to attain volume levels which aren't attainable without it. Nothing really specific other than to make sure you are recording as close to 0 db as possible without going over.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |